- When connecting third-party accessories.


- Both
S.BUS and the onboard ELRS receiver use the same UART3 port.
- The air unit connector is
JST SH 1.0 6-pin.
- The connector used to connect the flight controller to a computer for configuration is
JST SH 1.0 4-pin.
- The motor connectors are
JST MX 1.25 3-pin.
- The
UART4 solder pads on the front of the flight controller share the same UART with the air unit connector on the back. Only one of them can be used at a time.
UART1 only provides R1 and does not have T1.
- This flight controller only supports HD digital FPV systems and does not support analog FPV systems.