- The radio control signal is weak during flight, or the connection may even be lost.
- Try flying with a different Drone. If multiple Drones all experience weak signal, the issue may be caused by the radio controller itself.
Try increasing the transmit power of the ELRS RF module instead of using Auto Power.
- The Curve C16 and P18 use a relatively conservative warning threshold by default. During flight, the OSD may begin flashing a warning even at a relatively short distance. This is intended to remind beginners not to fly too far away and to return in time.
This does not necessarily indicate a fault. The warning threshold is simply set relatively low. You can connect to Betaflight Configurator and change the warning value to −80.

- The receiver antenna on the Curve flight controller is a copper wire.
- Check whether the antenna on the flight controller is loose or damaged. Gently move it by hand to check for a poor solder joint.
- Check whether the antenna has become noticeably shorter.
- If the antenna length is normal and there is no obvious poor solder joint, the issue may be caused by the receiver on the flight controller itself.
- The flight controller may become deformed or bent upward after a strong impact during flight and then collide with the air unit board above it. It is recommended to contact after-sales support for technical assistance.
- To help prevent this from happening again, you can remove the support structure at the bottom of the frame, or place a firm foam pad between the two boards to prevent them from directly colliding.

Avoid severe impacts during flight, as they may deform or damage the flight controller.